Washing machine late maintenance
First, take out the coins and debris in the pocket before washing. The clothes with metal buttons should be buckled on the metal buttons, and the clothes should be turned over so that the metal buttons are not exposed to prevent the metal and other hard objects from being damaged during the washing process. Bucket and pulsator. Sediment, hard objects, and sand are worn in the washing tub, which will wear the shaft seal and cause water leakage; while the hard object will damage or catch the pulsator, causing the motor to overload and burn out.
Second, the amount of laundry should not exceed the specified amount of the washing machine, the amount of water should not be lower than the mark of the lower line, so as to avoid overheating of the motor due to excessive load, resulting in insulation aging affecting the life. Ordinary washing machines all have a nominal laundry weight. If too much laundry is put in the laundry, not only the tumbling is poor, the wear rate is high, the washing degree is low, and the motor may be burnt due to overload.
Third, pay attention to the amount of water, too much water does not necessarily have a good washing effect, but will cause water to overflow; too little water, it may affect the washing effect, increase the wear and tear of the laundry. Generally, when washing 1.5 kilograms of clothing, the water consumption is about 30 kilograms; 3 to 5 kilograms of clothing is about 50 kilograms, and only when the water is moderate, the clothes can be evenly rolled and the washing degree is also high.
Fourth, the temperature of the washing water should not be too high, generally 40 ° C is appropriate, the highest should not exceed 60 ° C (except for the drum high temperature disinfection washing machine), so as not to burn the laundry tub or cause plastic aging and deformation. If you need to use warm heating, you should first put cold water in the washing machine bucket and then heat the water. If the temperature is too high, the machine will be damaged.
5. After each laundry, drain the sewage, clean the washing machine bucket with clean water; dry the water droplets and accumulated water inside and outside the washing machine with a dry cloth; return the knobs and buttons on the operation panel to the original position; the drain switch indicates Close the position and place it in a dry, ventilated place.
6. Do not use strong alkali, gasoline, olefin and hard brush when washing the washing machine. Do not use hard tools when cleaning the filter and drain.
Seven, always pay attention to check the power leads, found that there is damage or aging, should be dealt with in a timely manner.
8. Some washing machines have oil-filled holes on the pulsator sleeves, and oil cans can be added to the oil holes every two or three months.
Nine, pay attention to washing time. The washing time is long, the effect is not necessarily good, and the washing degree is obvious when the washing starts, but after a certain period of time, the washing degree is difficult to be further increased, and at this time, the wear rate of the laundry is increased.
10. In normal times, the metal casing and electrical parts of the washing machine are insulated. For some reason, when the insulation performance of the electrical part is reduced or destroyed, the metal casing is charged. At this time, if the human body touches the water-immersed clothing or the metal casing, it may cause an electric shock. Therefore, when using the washing machine, be sure to keep the grounding wire safe and good.
We offer a complete range of BS table flanges for use with OD tube and nominal bore pipe in carbon steel and stainless steel to tables D, E, F, and H. Specials can be manufactured to customers' special requirements. We offer a range of ASA 150LB raised face, weld neck, blind and slip-on flanges in grades A105, Q235 and 304, 316 to ASTM A182 specification.
BS Flanges,BS4504 Flanges,Steel Forged Flanges,BS 4504 Carbon Steel Flanges
Shandong Zhongnuo Heavy Industry Co.,Ltd. , https://www.znforged.com