Slurry pump start running should pay attention to the problem

At present, the industrial development of slurry pump gradually matures. So in the course of what should pay attention to what? 1, the slurry pump is mainly for the purpose of conveying flow, so in the operation of the monitoring system is best fitted flow meter (meter), in order to monitor the flow at any time to meet the requirements; equipped with cyclone pipeline system, slag system Filter press dewatering system also requires a certain pressure at the exit of the pipeline. Therefore, in this system should also be fitted with pressure gauge to monitor whether the pressure meets the requirements. 2, slurry pump should be started before the pump inlet valve, close the pump outlet valve. Then start the pump, start the pump and then slowly start the pump outlet valve, pump outlet valve opening size and speed, the pump should not vibrate and the motor does not exceed the rated current to grasp. 3, the pump in operation in addition to monitoring traffic, pressure, but also to monitor the motor do not exceed the rated current of the motor. Always monitor oil seals, bearings and other normal phenomenon occurs, the pump takes place or overflow pool, etc., and at any time. 4, series pump with the start, also follow the above method. Just open a pump, you can end of the pump outlet valve to find a little (open size to a pump motor current rated current of 1/4 is appropriate), and then you can start two three Until the last stage pump, tandem pump all started, you can gradually open the last stage of the pump outlet valve, the size of the valve to open the speed, the pump should not vibrate and any level of pump motor is not over-rated current to grasp. For more information, please visit our shop in Asia Pump Network:. ?