SB plastic electric drum oil pump use, use and maintenance points

[Asia Pump Network News] SB plastic electric drum pump can be directly inserted into the bucket to extract liquid in the bucket, you can transport a variety of fuel, with a corrosive chemical syrup and other liquids. Now to introduce SB type plastic electric drum pump product use, use and maintenance of what is the point. SB plastic electric oil drum pump SB plastic electric drum pump Product use This series of drum pump can transport acid, alkali, salt, oil, beverages and other media, widely used in chemical, petrochemical, fine chemicals, dyes Chemical industry, environmental protection, water treatment, medicine, food and other departments. At the same time for small and medium sized oil fields, oil depots, refineries, gas stations, farm stations, enterprises and institutions, the fleet, vehicles and other transport gas petrol, kerosene, diesel, the ideal tool for light oil. Second, the use of SB type plastic electric drum pump and maintenance points ⒈ voltage shall not exceed the specified voltage on the nameplate ± 10 ℃. ⒉ before use must check the wire without damage before use. ⒊ prohibit the use of special environments such as hot and humid places. ⒋ Do not connect or change the wires for any length, do not take the power cord to lift the motor, do not touch with oil or heat source, prevent the power cord from scratching and sticking. ⒌ motor without a plug, a user selection of explosion-proof plug, plug must be installed above the 10A air circuit breakers and leakage protection device. In case of short circuit will automatically disconnect the power supply, the motor is no longer live. ⒍ If the brush friction sparks large, you can open the brush cover reload the brush, according to the original installed brush cover. ⒎ This pump is aspirated for a long time to stop, it is recommended to pump water and then clean, placed in a dry, clean and ventilated environment. New or long-term stand-by motors must measure the insulation resistance between all live parts and the metal parts that may be touched with a 550-volt megohmmeter before use. The operating temperature should not be less than 7 megohms. Further Reading: pump valve pipe fittings Exhibition 2016 Exhibition of Information Industry, Internet (Xiamen) Technology Co., Ltd. Author: Asian pumps Network Editor: Yao Xiaoxia (QQ / micro letter: 2355962924) http://beng.liuti.cn/ (Hotline : 400-6030-811)