Processing of large diameter thin wall eccentric sleeve
2022-08-31 12:06:26
We process hard aluminum (LY12) eccentric workpieces, the thinnest part is only 2.05mm. The eccentric clamp can control the deformation amount within 0.02mm, and ensure the other precision requirements of the drawing. The workpiece is positioned with φ150mm hole, and the inner hole step is pressed. Face, fine car out 57_ (-0.2) ~ 0. When using the eccentric car fixture semi-finished vehicle, make the eccentric mark on the fixture and the workpiece, and press the record when finishing the car, and finish the car φ164_(-0.000)~0 and outside the eccentric
Bath Shower Pod,Vcm Bathroom Pods,Shower And Toilet Pods,Freestanding Shower Pod
SALLY TECHNOLOGY CO.,LTD , https://www.sallyshowers.com