Engineering plastics pneumatic diaphragm pump removal method

How to dismantle the pump to repair it after the engineering plastic pneumatic diaphragm pump failure? With this question, the next to introduce the engineering plastics pneumatic diaphragm pump disassembly method. Engineering plastic pneumatic diaphragm pump removal method 1. Before removing the plastic pneumatic diaphragm pump, the left and right sides of the gas chamber and liquid chamber were marked to facilitate the subsequent reassembly action. 2. Use a wrench to loosen the small clamp connecting the outlet pipe to the liquid chamber. Remove the outlet pipe to see the ball and valve seat. Remove the ball and seat and inspect the pump for wear, chemical corrosion, cracks, etc. phenomenon. 3. Using a wrench, loosen the small clip that connects the inlet tube to the liquid chamber. 4. Use a wrench to separate the fluid chamber from the pump's intermediate body. Remove the fluid chamber to see the diaphragm and diaphragm clamp. 5. Use a tool or wrench to secure the left and right edges of the diaphragm clamp to separate the diaphragm assembly from the intermediate body. Then turn clockwise to loosen the diaphragm assembly. After removing the diaphragm from the clamp, remove the shaft from the intermediate body. 6. Use clamps (padded wood) to separate the shaft from the diaphragm assembly and check shaft, clamp, diaphragm for damage and corrosion. Extended reading: China Construction Water Exhibition water pump manufacturers rankings ptc exhibition motor top ten brands pump valve pipe fittings Show Information Industry Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: He Duanhui (QQ / WeChat: 2355962924) http: // mj .liuti.cn / (Service Hotline: 400-6030-811)