Introduction to SolidWorks2012 Equations
The equations in SolidWorks2012 have been greatly updated, redesigned the dialog box, and can be used to set and manage equations with simpler and more efficient methods; however, some previous operating habits may no longer be suitable. The application of the new equations below is applicable. Make a brief application note (a rectangular body, 2 times the width, 3 times the width, and the equation for the length and width):
1 How to add an equation?
The previous way of using toolbars and menus is still possible, but the way to double-click the size drop-down box no longer exists. It is changed to the same way as EXCEL to activate the equation by "=", which is faster than before.
Method 1:
Method 2: Click Tools > Equations
Method 3: Enter “=†directly in the length dimension input field, the function and file attribute shortcut keys shown in the figure below will appear. If not, click the width parameter directly. As shown in the figure below, the rectangle length value is rectangular. 2 times the width
Compared with the editing equation in the selection box of the old version, the dialog box pops up, which is more flexible and simpler than the previous operation;
Note (However, this method has only been tested for sketch size. For feature sizes, it cannot be operated in sequence. For example, the height value of a rectangle cannot be set directly by the "=" sign)
Method 4: Manage the equation by right-clicking the equation folder in the property bar:
The auger bit adds a long deep spiral flute for effective chip removal.
Two styles of auger bit are commonly used in hand braces: the Jennings or Jennings-pattern bit has a self-feeding screw tip, two spurs and two radial cutting edges. This bit has a double flute starting from the cutting edges, and extending several inches up the shank of the bit, for waste removal.
The Irwin or solid-center auger bit is similar, the only difference being that one of the cutting edges has only a "vestigal flute" supporting it, which extends only about 1â„2 in (13 mm) up the shank before ending.
The diameter of auger bits for hand braces is commonly expressed by a single number, indicating the size in 16ths of an inch. For example, #4 is 4/16 or 1/4 in (6 mm), #6 is 6/16 or 3/8 in (9 mm), #9 is 9/16 in (14 mm), and #16 is 16/16 or 1 in (25 mm). Sets commonly consist of #4-16 or #4-10 bits.
Extra Long Auger Bit,Auger Drill Bit,Drill Bit With Flute,Carbon Steel Wood Working
Behappy Crafts (suzhou)Co.,Ltd , https://www.behappyindustry.com