Basic operation method of ginseng slicer
2019-06-05 16:03:50
The ginseng slicer is equipped with single-phase motor, adopts high-grade bearing, and installs four blades on the cutter head. The speed ratio is slow and the slicing effect is high. The slice thickness can be adjusted. It is widely used in Chinese pharmacies, pharmacies, Chinese medicine processing plants, etc. The machine has the characteristics of small volume, high efficiency, simple operation, exquisite and beautiful, that is, power saving and safety. Instructions: 1. Adjustment: firstly loosen the fixing copper column nut, then adjust the thickness direction of the nut and the copper column. After the thickness is adjusted, the nut and the copper column must be tightened. Do not switch the cutter if it is parallel to the blade. The cutter must be lower than the blade to start cutting. The adjustment is about 3mm thick, and the thin is steplessly modulated. 2. Replace the blade: Insert the hexagonal handle into the side hole of the machine. Rotate to adjust the direction of the disk and then change the knife. When the tool is changed, loosen the two hexagonal screws of the blade and insert the blade to replace it. Steps for usage: 1. Slicing step: preparation - feeding - slicing - discharging 2, preparation: prepare the materials that need to be sliced, tray 3. Incoming material: take out the plastic stamper, adjust the thickness of the slice, and after opening the machine, put the material into the feeding port. 4. Slice: press the material tightly by hand or die, the material is automatically sliced, and two pieces can be cut by one rotation. 5, discharging: discharging from the discharge port skills: 1. Preparation stage: It should be noted that the wet material is better than the dry one. The too dry material may be cut into powder. If the material is too dry and too hard, you can choose to soften the material and then slice it. Highly viscous materials can be adjusted to a high slice thickness. 2. Feeding stage: When feeding, when the small block material is sliced, the plastic stamper is used to press the slice, otherwise there will be material jumping phenomenon, which will not be cut; if the material is a bit large, the material can be processed into the first The size of the inlet port is then sliced. Author: Chang Hong medicine machine This article links: http:// Copyright @Reprinted must indicate the author and original source in the form of a link |
Fine Chemicals, Speciality Chemicals, Fine Chemical Additive
Dynasty Chemicals (NingBo) Co., Ltd. , http://www.dychemco.com