Active infrared intrusion detector installation considerations
Lecor infrared is composed of a front cover, a receiver, a transmitter, and a metal plate.
Installation Precautions:
1. Avoid facing strong sunlight, car headlights, etc. Avoid reflections from the transmitter or receiver.
2. Do not install on unstable surfaces.
3. Take into account seasonal changes and do not install in places where light beams may be blocked by leaves or plants.
4. Do not install it in a place that may be bombarded with dirty water or be splashed directly by the waves.
Installation method:
Can be wall-mounted, but also can be installed column.
Main features: Unique aspheric lens and super beam make the optical system's performance ten times better than the detection distance reserve, avoid the false reliability caused by rain, snow, fog, etc., with automatic gain control AGC using external strong Optical compensation filter to eliminate external light interference and convenient beam calibration, with special observer and standard level monitor output angle adjustment, horizontal position ±90° and vertical position ±10° frost protection, dew protection, detector front cover is Special anti-frost design Protects against insects, sealed optical system IP55 dust and water proof protection Easy installation and wiring
Technical Parameters:
Model number
RK-PB30SA
RK-PB60SA
RK-PB80SA
RK-PB100SA
Protection distance
Outdoor 30m
Outdoor 60m
Outdoor 80m
100m outdoor
Indoor 60m
Indoor 120m
Indoor 160m
Indoor 200m
Maximum beam distance
300m outdoor
Outdoor 600m
Outdoor 800m
Outdoor 1,000m
Indoor 300m
Indoor 600m
Indoor 800m
Indoor 1,000m
Power consumption
Up to 57mA
Up to 57mA
80mA maximum
88mA max
Detection method
2 light beams are blocked at the same time
Infrared beam
LED double modulated pulsed light beam
powered by
10.8V--25V DC (non-polarity)
Response time
50ms--700ms
led
launcher
Green LED is bright: Power is on
receiver
Green LED is on (sensitivity is best) Red is on: Alarm is started
Alarm Output
Dry contact relay output form C
Contact action: Interrupted time + delay time (1-3 s)
Contact capacity: 30V (AC/DC) not more than 1A
Tamper output
Dry contact relay output form N/C (receiver only)
Contact action: start with front cover open
Contact capacity: 30V (AC/DC) not more than 1A
temperature
-20~60°C
-25~70°C
Beam adjustment
Level: 180' ± 90°; Vertical: 20' ± 10°
Installation position
Outdoor/indoor
Materials
PC resin
Protection IP level
IP55
Dimensions
73×167×78mm Weight Rx: 338g, Tx: 324g
Features
Monitoring hole output, anti-frost cover, AGC
Accessories
Column fittings (2 pieces/set, column size: 38-44mm / tamper switch for transmitter)
CSA cement is considered as calcium sulphate aluminium cement. It shows the performance of high strength, rapid hardening or fast setting, corrosion resistance and carbonation resistance. It can be used in many fast setting applications such as non-shrink grout, self-leveling compound, fast setting tile adhesive or tile grout and fast setting repair system etc.
sulphate aluminium cement,calcium sulphate aluminium,fast-setting cement,rapid hardening mortar; fast setting repair
Shanghai Na Long Tech Co., Ltd , https://www.na-long.com