ThinkDesign Teapot Modeling Process (4)
2022-10-11 13:06:42
Use the function of the tubular surface to create small beads on both sides of the handle as shown below.
Next, you need to create a spout part, and extend the curve that creates the spout a small section to make a tubular surface as the base of the spout part. Then create a curve as shown in the figure, rotate it to get a surface, add thickness 0.5mm to the surface.
Previous page next page
Shower Accessory,Shower Rod,Shower Curtain Rings,Shower Holder
Kaiping Rainparty Sanitary Ware Technology Co.,Ltd. , https://www.helin-shower.com